Описание

Amplifier Unit, DIN Rail Type, PNP
Model GT-72AP
Type Amplifier unit
Output PNP output
Mounting type DIN rail mount*1
Main unit/Expansion unit Expansion unit*2
Power consumption Normal At 12 V: 1,140 mW (95 mA) or less, At 24 V: 1,200 mW (50 mA) or less
Power saving (Eco) At 12 V: 600 mW (50 mA) or less, At 24 V: 840 mW (35 mA) or less
Display power Measured value display 6-digit 7-segment LED (red)
Other displays 2-colour 13-level bar LED display (red, green), indicators (red, green)
Display range -99.999 to 999.999
Display resolution 1 µm
Sampling rate 2,000 times/second
Control input Timing/preset/bank input Timing input: Non-voltage input (relay contact, solid state), input time: 2 ms or more Preset/Bank input: Non-voltage input (relay contact, solid state), input time: 20 ms or more
Response time hsp (1.5 ms) , 5 ms, 10 ms, 100 ms, 500 ms, 1 s, 5 s
HIGH, GO, LOW output PNP Offenkollektor, max. 50 mA (40 V oder weniger), Restspannung: 1 V oder weniger, N.O./N.C. umschaltbar
Major functions Preset, Hold, Variable hysteresis, Variable response time, Multiplier setting, Bank function (4 banks), Self-timing, Power save (eco) mode, Application mode, Calibration function, Core alarm
Rating Power voltage 12 to 24 VDC, Ripple (P-P) 10 % or less*3
Environmental resistance Ambient temperature -10 to +55 °C (No freezing)
Relative humidity 35 to 85 % RH (No condensation)
Vibration resistance 10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z directions
Material Main body case: Polycarbonate, Key top: Polyacetal, Front sheet: Polycarbonate, Cable: PVC
Accessories Instruction manual
Weight Approx. 110 g (including the power cable)
*1 Be sure to mount the DIN rail mounting amplifier on a DIN rail (i.e. the unit should be mounted on the metal DIN plate itself). For additional amplifier unit installation, be sure to use the end unit (OP-26751). *2 One main unit and nine expansion units (ten in total) can be additionally installed. For additional amplifier unit installation, each output current must be 20 mA or less. *3 If additional amplifier units are installed, the power supply voltage is 24 VDC.
''